Set is designed to work with BK Precision Models 2615, 2620, 2625, and 2630 Spectrum Analyzers. It includes one Magnetic Field Probe, one Electric Field Probe and one High Impedance Probe.Probes feature a built-in pre-amplifier covering the frequency range from 10kHz to 1GHz (depending on probe type), have high sensitivity, and are matched to the 50 Ohms inputs of Spectrum Analyzers. Power can be supplied either from four AA batteries (not included) or through a power cord directly connected to the Spectrum Analyzer. Signal feed is via a 1.5m BNC cable.When used with a Spectrum Analyzer, the probes can be used to locate and qualify EMI sources. Probes are especially suited to locate emission "hot spots" on PCBs and cables, as well as to evaluate EMC problems at the breadboard and prototype level. They enable the user to evaluate radiated fields and perform shield effectivity comparisons. Mechanical screening performance and immunity tests on cable and components are easily performed. Faulty components and poor bonding locations can be isolated.The Magnetic Field Probe incorporates a high degree of rejection of both stray and direct electric fields, and provides far greater repeatability than with conventional field probes. Measurements can be made on the very near field area that is close to components or radiation sources.The Electric Field Probe (mono-pole) has the highest sensitivity of all three probes. It can be used to check screening and perform pre-compliance testing on a comparative basis.The High Impedance Probe is used to measure directly on the components under test or at the conductive trace of a PC board. It has an input capacitance of only 2pF and supplies virtually no electrical charge to the device under test.Set includes Magnetic Field Probe, Electric Field probe, High Impedance Probe, BNC Cable (1.5m), Power Supply Cable, and Carrying Case.
Also known as PR261 PR-261 110568
Home | Site Map